CISCO-WAN-SRCP-MIB
47 objects
The MIB module for managing SRCP(Simple Resource Coordination Protocol) implementations. SRCP is a resource coordination protocol used between a MGC(Media Gateway Controller) and a MG(Media Gateway). SRCP MIB is applicable to both controllers (SRCP clients) and gateways (SRCP servers). MGMIB: This is the short name used for CISCO-WAN-MG-MIB in this MIB.
Imported Objects
| CISCO-WAN-MGC-REDUN-MIB | mgcRedundancyGrpNum |
| CISCOWAN-SMI | ciscoWan |
| SNMPv2-CONF | MODULE-COMPLIANCE OBJECT-GROUP |
| SNMPv2-SMI | Counter32 Integer32 IpAddress MODULE-IDENTITY OBJECT-TYPE |
| SNMPv2-TC | DisplayString |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.351.150.11 | IdentityciscoWanSrcpMIB | The MIB module for managing SRCP(Simple Resource Coordination Protocol) implementations. SRCP is a resource coordination protocol used between a MGC(Media Gate… | ||
| 1.3.6.1.4.1.351.150.11.1 | NodesrcpObjects | |||
| 1.3.6.1.4.1.351.150.11.1.1 | NodesrcpAdminObjects | |||
| 1.3.6.1.4.1.351.150.11.1.1.1 | ScalarsrcpVersion | read-only | current | The name of the SRCP protocol version for exmaple SRCP 1.0.2. If MGMIB is supported, this name corresponds to mgProtocolName (defined in CISCO-WAN-MG-MIB MIB) … |
| 1.3.6.1.4.1.351.150.11.1.1.2 | ScalarsrcpPortNumber | read-write | current | This object is used to configure the UDP port used for SRCP on the system (local UDP port). It is configurable only if the system is in a locked or disabled st… |
| 1.3.6.1.4.1.351.150.11.1.1.3 | TablesrcpPeerTable | not-accessible | current | This is a table which is used to provision peer-specific SRCP configuration and administration information. Each table entry corresponds to an SRCP peer as ide… |
| 1.3.6.1.4.1.351.150.11.1.1.3.1 | RowsrcpPeerEntry | not-accessible | current | Represents an individual table entry in srcpPeerTable. Each row corresponds to an SRCP peer and is identified by its domain name (srcpPeerName). Entries in thi… |
| 1.3.6.1.4.1.351.150.11.1.1.3.1.1 | ColumnsrcpPeerId | not-accessible | current | This object identifies the SRCP peer and serves as index to this table. If MGMIB is supported, this is the same as the mgcNumber(defined in CISCO-WAN-MG-MIB MI… |
| 1.3.6.1.4.1.351.150.11.1.1.3.1.2 | ColumnsrcpPeerName | read-only | current | This object identifies the name of the SRCP peer. If MGMIB is supported, this is the same as the mgcName from the mgcTable. |
| 1.3.6.1.4.1.351.150.11.1.1.3.1.3 | ColumnsrcpPeerPortNumber | read-write | current | This object is used to configure the UDP port of the SRCP peer. |
| 1.3.6.1.4.1.351.150.11.1.1.3.1.4 | ColumnsrcpPeerHeartbeatInterval | read-write | deprecated | This object is used to configure the length of the heartbeat interval, in milliseconds. The heartbeat interval indicate when the GW(Gateway) is expected to rec… |
| 1.3.6.1.4.1.351.150.11.1.1.3.1.5 | ColumnsrcpPeerTimeSinceHeartbeat | read-only | deprecated | The time since the last heartbeat was received, in milliseconds. This represents the difference between the current time and the last time an SRCP command was … |
| 1.3.6.1.4.1.351.150.11.1.1.3.1.6 | ColumnsrcpPeerMaxPduSize | read-write | deprecated | This object is used to configure the maximum UDP PDU(Protocol Data Unit) size, in octets, that may be used for SRCP communications with the peer. This value ma… |
| 1.3.6.1.4.1.351.150.11.1.1.4 | TablesrcpPeerGrpParamTable | not-accessible | current | This table is used to provision SRCP parameters for an MGC Redundancy group. MGCs can be configured as part of MGC Redundancy groups. This feature allows for r… |
| 1.3.6.1.4.1.351.150.11.1.1.4.1 | RowsrcpPeerGrpParamEntry | not-accessible | current | Represents an individual table entry in the srcpPeerGrpParamTable. Each row corresponds to an MGC Redundancy Group and is identified by the MGC Redundancy Grou… |
| 1.3.6.1.4.1.351.150.11.1.1.4.1.1 | ColumnsrcpPeerGrpHeartbeatInterval | read-write | current | This object is used to configure the length of the heartbeat interval, in milliseconds. If 0, heartbeat for this peer Group is not monitored. The heartbeat int… |
| 1.3.6.1.4.1.351.150.11.1.1.4.1.2 | ColumnsrcpPeerGrpTimeSinceHeartbeat | read-only | current | The time since the last heartbeat was received, in milliseconds. This represents the difference between the current time and the last time an SRCP command was … |
| 1.3.6.1.4.1.351.150.11.1.1.4.1.3 | ColumnsrcpPeerGrpMaxPduSize | read-write | current | This object is used to configure the maximum UDP PDU size, in octets, that may be used for SRCP communications with the peer. This value may not be configurabl… |
| 1.3.6.1.4.1.351.150.11.1.2 | NodesrcpStatsObjects | |||
| 1.3.6.1.4.1.351.150.11.1.2.1 | TablesrcpPeerStatsTable | not-accessible | current | This table contains SRCP statistics information since reset. SRCP statistics are kept in this table, with each table entry containing the statistics of SRCP me… |
| 1.3.6.1.4.1.351.150.11.1.2.1.1 | RowsrcpPeerStatsEntry | not-accessible | current | The row of the srcpPeerStatsTable contains information about SRCP message statistics per IP address of the MGC. An entry is implicitly created and deleted by t… |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.1 | ColumnsrcpStatsPeerIpAddress | not-accessible | current | This object specifies the IP address of the SRCP peer and serves as index to the table. |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.2 | ColumnsrcpStatsPeerName | read-only | current | Denotes the name of the SRCP peer. This is the same as the mgcName from the mgcTable. It is provided here as a read-only parameter as a convinience feature. |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.3 | ColumnpacketsDiscardedCnts | read-only | current | The number of packets that were received and discarded. The packets may get discarded because of indecipherable PDUs like bad protocol version, bad command ver… |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.4 | ColumnaugwCnts | read-only | current | The total number of AUGW(Audit Gateway) commands received from the peer on this IP address. |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.5 | ColumnaulnCnts | read-only | current | The total number of AULN(Audit Line) commands received from or sent to the peer on this IP address. |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.6 | ColumnrqntCnts | read-only | current | The total number of RQNT(Notification Request) commands received from or sent to the peer on this IP address. |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.7 | ColumnntfyCnts | read-only | current | The total number of NTFY(Notify) commands received from or sent to the peer on this IP address. |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.8 | ColumnaugwFailCnts | read-only | current | For MG : The total number of AUGW commands received that were responded to with a failure return code. For MGC : The total number of AUGW commands sent which w… |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.9 | ColumnaulnFailCnts | read-only | current | Media gateway : The total number of AULN commands received that were responded to with a failure return code. Media gateway controller : The total number of AU… |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.10 | ColumnrqntFailCnts | read-only | current | Media gateway : The total number of RQNT commands received that were responded to with a failure return code. Media gateway controller : The total number of RQ… |
| 1.3.6.1.4.1.351.150.11.1.2.1.1.11 | ColumnntfyFailCnts | read-only | current | Media gateway : The total number of NTFY commands sent which were timed out without a response or for which a response with failure return code was received. M… |
| 1.3.6.1.4.1.351.150.11.1.3 | NodesrcpAdminRetyObjects | |||
| 1.3.6.1.4.1.351.150.11.1.3.1 | ScalarsrcpRequestTimeOut | read-write | current | This object specifies the minimum timeout value. This value along with srcpRequestMaxTimeout and srcpRequestRetries is used to determine the exponential retry … |
| 1.3.6.1.4.1.351.150.11.1.3.2 | ScalarsrcpRequestRetries | read-write | current | This object specifies the number of retries for a SRCP request that exceeds timeout. It is the responsibility of the requesting entity to provide suitable time… |
| 1.3.6.1.4.1.351.150.11.1.3.3 | ScalarsrcpRequestMaxTimeout | read-write | current | This object specifies the maximum timeout value. This timer value is used along with srcpRequestTimeOut and srcpRequestRetries to determine the exponential ret… |
| 1.3.6.1.4.1.351.150.11.3 | NodesrcpMIBConformance | |||
| 1.3.6.1.4.1.351.150.11.3.1 | NodesrcpMIBCompliances | |||
| 1.3.6.1.4.1.351.150.11.3.1.1 | CompliancesrcpMIBCompliance | deprecated | The compliance statement for the SNMPv2 entities which implement SRCP MIB. | |
| 1.3.6.1.4.1.351.150.11.3.1.2 | CompliancesrcpMIBComplaince2 | deprecated | The compliance statement for the SNMPv2 entities which implement SRCP MIB. | |
| 1.3.6.1.4.1.351.150.11.3.1.3 | CompliancesrcpMIBComplaince3 | current | The compliance statement for the SNMPv2 entities which implement SRCP MIB. | |
| 1.3.6.1.4.1.351.150.11.3.2 | NodesrcpMIBGroups | |||
| 1.3.6.1.4.1.351.150.11.3.2.1 | GroupsrcpConfigurationGroup | deprecated | This group contains objects related to configuration of SRCP. Min Access of read only is permissible for system providing only a fixed SRCP port. | |
| 1.3.6.1.4.1.351.150.11.3.2.2 | GroupsrcpStatisticsGroup | deprecated | This group contains the statistics per SRCP peer. | |
| 1.3.6.1.4.1.351.150.11.3.2.3 | GroupsrcpConfigurationGroup2 | deprecated | This group contains objects related to configuration of SRCP. Min Access of read only is permissible for system providing only a fixed SRCP port. | |
| 1.3.6.1.4.1.351.150.11.3.2.4 | GroupsrcpStatisticsGroup2 | current | This group contains the statistics per SRCP peer. | |
| 1.3.6.1.4.1.351.150.11.3.2.5 | GroupsrcpConfigurationGroup3 | current | This group contains objects related to configuration of SRCP. Min Access of read only is permissible for system providing only a fixed SRCP port. |