DGS3216-SWL3MGMT-MIB
47 objects
The Structure of Layer 3 Network Management Information for the proprietary enterprise.
Imported Objects
| IF-MIB | InterfaceIndex |
| SNMPv2-SMI | Counter32 Integer32 IpAddress MODULE-IDENTITY NOTIFICATION-TYPE OBJECT-TYPE Unsigned32 |
| SNMPv2-TC | DisplayString MacAddress PhysAddress RowStatus TimeStamp TruthValue |
| SW3200PRIMGMT-MIB | dgs3216 |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.171.11.101.2.3 | IdentityswL3MgmtMIB | The Structure of Layer 3 Network Management Information for the proprietary enterprise. | ||
| 1.3.6.1.4.1.171.11.101.2.3.2 | NodeswL3IpMgmt | |||
| 1.3.6.1.4.1.171.11.101.2.3.2.1 | NodeswL3IpCtrlMgmt | |||
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3 | TableswL3IpCtrlTable | not-accessible | current | This table contains IP interface information. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1 | RowswL3IpCtrlEntry | not-accessible | current | A list of information about a specific IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.1 | ColumnswL3IpCtrlInterfaceName | read-only | current | This object indicates the name of the IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.2 | ColumnswL3IpCtrlIfIndex | read-only | current | This object uniquely identifies the IP interface number in the swL3IpCtrlTable. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.3 | ColumnswL3IpCtrlIpAddr | read-write | current | The IP address of the interface. This object only can take the value of the unicast IP address. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.4 | ColumnswL3IpCtrlIpSubnetMask | read-write | current | The IP net mask for this interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.5 | ColumnswL3IpCtrlVlanName | read-write | current | This object indicates the IP control entry's VLAN name. The VLAN name in each entry must be unique in the IP Control Table. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.8 | ColumnswL3IpCtrlMode | read-write | current | This object indicates the IP operation mode. other(1) - This entry is currently in use but the conditions under which it will remain are determined by each of … |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.9 | ColumnswL3IpCtrlAdminState | read-write | current | The state of the IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.14 | ColumnswL3IpCtrlIpv6LinkLocalAddress | read-only | current | The IPv6 link local address for this interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.15 | ColumnswL3IpCtrlIpv6LinkLocalPrefixLen | read-only | current | The IPv6 prefix length for this IPv6 link local address. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.16 | ColumnswL3IpCtrlState | read-create | current | This variable displays the status of the entry. The status is used for creating, modifying, and deleting instances of the objects in this table. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.17 | ColumnswL3IpCtrlIpv6LinkLocalAutoState | read-write | current | The state of the IPv6 link local auto. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.20 | ColumnswL3IpCtrlDhcpv6ClientState | read-write | current | The object indicates the state of the DHCPv6 client. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.22 | ColumnswL3IpCtrlIpDhcpOption12State | read-write | current | Enable or disable insertion of option 12 in the DHCPDISCOVER and DHCPREQUEST message. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.3.1.23 | ColumnswL3IpCtrlIpDhcpOption12HostName | read-write | current | Specify the host name to be inserted in the DHCPDISCOVER and DHCPREQUEST message. The specified host name must start with a letter, end with a letter or digit,… |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4 | TableswL3Ipv6CtrlTable | not-accessible | current | This table contains IPv6 information of an IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1 | RowswL3Ipv6CtrlEntry | not-accessible | current | A list of IPv6 information about a specific IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.1 | ColumnswL3Ipv6CtrlInterfaceName | read-only | current | This object indicates the name of the IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.2 | ColumnswL3Ipv6CtrlMaxReassmblySize | read-only | current | Maximum Reassembly Size of the IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.3 | ColumnswL3Ipv6CtrlNsRetransTimer | read-write | current | Neighbor solicitation's retransmit timer. The unit is set in milliseconds. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.5 | ColumnswL3Ipv6CtrlRaState | read-write | current | Neighbor solicited state. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.6 | ColumnswL3Ipv6CtrlRaMinRtrAdvInterval | read-write | current | The minimum time allowed between sending unsolicited multicast Router Advertisements from the interface. The unit is set in seconds. It must be no less than 3 … |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.7 | ColumnswL3Ipv6CtrlRaMaxRtrAdvInterval | read-write | current | The maximum time allowed between sending unsolicited multicast Router Advertisements from the interface. The unit is set in seconds. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.8 | ColumnswL3Ipv6CtrlRaLifeTime | read-write | current | Indicates the lifetime of the router as the default router. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.9 | ColumnswL3Ipv6CtrlRaReachableTime | read-write | current | Indicates the amount of time that a node can consider a neighboring node reachable after receiving a reachability confirmation. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.10 | ColumnswL3Ipv6CtrlRaRetransTime | read-write | current | Indicates the amount of time between retransmissions of neighbor solicited messages. The unit is set in millisecond. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.11 | ColumnswL3Ipv6CtrlRaHopLimit | read-write | current | Indicates the default value of the hop limit field in the IPv6 header for packets sent by hosts that receive this RA message. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.12 | ColumnswL3Ipv6CtrlRaManagedFlag | read-write | current | When enabled, it indicates that hosts receiving this RA must use a stateful address configuration protocol to obtain an address in the addition to the addresse… |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.4.1.13 | ColumnswL3Ipv6CtrlRaOtherConfigFlag | read-write | current | When enabled, it indicates that hosts receiving this RA must use a stateful address configuration protocol to obtain an on-link address configuration informati… |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5 | TableswL3Ipv6AddressCtrlTable | not-accessible | current | This table contains IPv6 address information for each IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1 | RowswL3Ipv6AddressCtrlEntry | not-accessible | current | A list of information about a specific IPv6 address. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.1 | ColumnswL3Ipv6AddressCtrlInterfaceName | read-only | current | This object indicates the name of the IP interface. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.2 | ColumnswL3Ipv6Address | read-only | current | Specify the IPv6 address. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.3 | ColumnswL3Ipv6AddressCtrlPrefixLen | read-only | current | Indicates the prefix length of this IPv6 address. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.4 | ColumnswL3Ipv6AddressCtrlPreferredLifeTime | read-write | current | Indicates the number of seconds that an address, based on the specified prefix, using the stateless address configuration, remains in preferred state. For an i… |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.5 | ColumnswL3Ipv6AddressCtrlValidLifeTime | read-write | current | Indicates the number of seconds that an address, based on the specified prefix, using the stateless address configuration, remains valid. For an infinite valid… |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.6 | ColumnswL3Ipv6AddressCtrlOnLinkFlag | read-write | current | When enabled, the address implied by the specified prefix is available on the link where the RA message is received. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.7 | ColumnswL3Ipv6AddressCtrlAutonomousFlag | read-write | current | When enabled, the specified prefix will be used to create an autonomous address configuration. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.8 | ColumnswL3Ipv6AddressCtrlState | read-create | current | This variable displays the status of the entry. The status is used for creating, modifying, and deleting instances of the objects in this table. |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.5.1.9 | ColumnswL3Ipv6AddressCtrlAddressType | read-only | current | This object indicates the type of the IPv6 address. manual(1): the IPv6 address is configured by user. dhcpv6(2): the IPv6 address is assigned by DHCPv6 server… |
| 1.3.6.1.4.1.171.11.101.2.3.2.1.7 | ScalarswL3IpCtrlAllIpIfState | read-write | current | This object indicates all interface function state of the device. |
Type Definitions
| Name | Syntax | Status | Description |
|---|---|---|---|
| Ipv6Address | OCTET STRING (SIZE (16)) | current | This data type is used to model IPv6 addresses. This is a binary string of 16 octets in network byte-order. |
| VrId | Integer32 (1..255) | current | A number which, along with an interface index (ifIndex), serves to uniquely identify a virtual router on a given VRRP router. A set of one or more associated addresses is assigned to a VRID. |