HP-SN-MPLS-TC-MIB
19 objects
This MIB module defines Textual Conventions and OBJECT-IDENTITIES for use in documents defining management information bases (MIBs) for managing MPLS networks.
Imported Objects
| HP-SN-ROOT-MIB | snMpls |
| RFC1213-MIB | transmission |
| SNMPv2-SMI | Integer32 MODULE-IDENTITY Unsigned32 |
| SNMPv2-TC | TEXTUAL-CONVENTION |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.11.2.3.7.11.12.2.15.15 | NodemplsMIB | |||
| 1.3.6.1.4.1.11.2.3.7.11.12.2.15.15.1 | IdentitymplsTCMIB | This MIB module defines Textual Conventions and OBJECT-IDENTITIES for use in documents defining management information bases (MIBs) for managing MPLS networks. |
Type Definitions
| Name | Syntax | Status | Description |
|---|---|---|---|
| MplsAtmVcIdentifier | Integer32 (32..65535) | current | The VCI value for a VCL. The maximum VCI value cannot exceed the value allowable by atmInterfaceMaxVciBits defined in ATM-MIB. The minimum value is 32, values 0 to 31 are reserved for other uses by the ITU and ATM Forum… |
| MplsBitRate | Integer32 (1..2147483647) | current | An estimate of bandwidth in units of 1,000 bits per second. If this object reports a value of 'n' then the rate of the object is somewhere in the range of 'n-500' to 'n+499'. For objects which do not vary in bit rate, o… |
| MplsBurstSize | Unsigned32 (1..4294967295) | current | The number of octets of MPLS data that the stream may send back-to-back without concern for policing. |
| MplsExtendedTunnelId | Unsigned32 | current | A unique identifier for an MPLS Tunnel. This MAY represent an IpV4 address of the ingress or egress LSR for the tunnel. This value is derived from the Extended Tunnel Id in RSVP or the Ingress Router ID for CR-LDP. |
| MplsInitialCreationSource | INTEGER { other(1), snmp(2), ldp(3), rsvp(4), crldp(5), policyAgent(6), unknown (7) } | current | The entity that originally created the object in question. The values of this enumeration are defined as follows: other(1) - This is used when an entity which has not been enumerated in this textual convention but which… |
| MplsLabel | Unsigned32 (0..4294967295) | current | This value represents an MPLS label as defined in [RFC3031], [RFC3032], [RFC3034] and [RFC3035]. |
| MplsLdpGenAddr | OCTET STRING (SIZE (0..64)) | current | The value of an network layer or data link layer address. |
| MplsLdpIdentifier | OCTET STRING (SIZE (6)) | current | The LDP identifier is a six octet quantity which is used to identify an Label Switch Router (LSR) label space. The first four octets identify the LSR and must be a globally unique value, such as a 32-bit router ID assig… |
| MplsLdpLabelTypes | INTEGER { generic(1), atm(2), frameRelay(3) } | current | The Layer 2 label types which are defined for MPLS LDP/CRLDP are generic(1), atm(2), or frameRelay(3). |
| MplsLSPID | OCTET STRING (SIZE (0..31)) | current | An identifier that is assigned to each LSP and is used to uniquely identify it. This is assigned at the head end of the LSP and can be used by all LSRs to identify this LSP. This value is piggybacked by the signaling pr… |
| MplsLsrIdentifier | OCTET STRING (SIZE (4)) | current | The Label Switch Router (LSR) identifier is the first 4 bytes of the Label Distribution Protocol (LDP) identifier. |
| MplsPathIndex | Unsigned32 | current | A unique identifier used to identify a specific path used by a tunnel. |
| MplsPathIndexOrZero | Unsigned32 | current | A unique identifier used to identify a specific path used by a tunnel. If this value is set to 0, it indicates that no path is in use. |
| MplsPortNumber | Integer32 (0..65535) | current | A TCP or UDP port number. Along with an IP address identifies a stream of IP traffic uniquely. |
| MplsTunnelAffinity | Unsigned32 | current | Include-any, include-all, or exclude-all constraint for link selection. |
| MplsTunnelIndex | Integer32 (1..65535) | current | Index into mplsTunnelTable. |
| MplsTunnelInstanceIndex | Unsigned32 (0..65535) | current | Instance index into mplsTunnelTable. |