INTEGRATED-SERVICES-MIB
54 objects
The MIB module to describe the Integrated Services Protocol
Imported Objects
| IF-MIB | ifIndex InterfaceIndex |
| SNMPv2-CONF | MODULE-COMPLIANCE OBJECT-GROUP |
| SNMPv2-SMI | Counter32 Gauge32 Integer32 mib-2 MODULE-IDENTITY OBJECT-TYPE |
| SNMPv2-TC | RowStatus TestAndIncr TEXTUAL-CONVENTION TimeInterval TruthValue |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.2.1.52 | IdentityintSrv | The MIB module to describe the Integrated Services Protocol | ||
| 1.3.6.1.2.1.52.1 | NodeintSrvObjects | |||
| 1.3.6.1.2.1.52.1.1 | TableintSrvIfAttribTable | not-accessible | current | The reservable attributes of the system's in- terfaces. |
| 1.3.6.1.2.1.52.1.1.1 | RowintSrvIfAttribEntry | not-accessible | current | The reservable attributes of a given inter- face. |
| 1.3.6.1.2.1.52.1.1.1.1 | ColumnintSrvIfAttribAllocatedBits | read-only | current | The number of bits/second currently allocated to reserved sessions on the interface. |
| 1.3.6.1.2.1.52.1.1.1.2 | ColumnintSrvIfAttribMaxAllocatedBits | read-create | current | The maximum number of bits/second that may be allocated to reserved sessions on the inter- face. |
| 1.3.6.1.2.1.52.1.1.1.3 | ColumnintSrvIfAttribAllocatedBuffer | read-only | current | The amount of buffer space required to hold the simultaneous burst of all reserved flows on the interface. |
| 1.3.6.1.2.1.52.1.1.1.4 | ColumnintSrvIfAttribFlows | read-only | current | The number of reserved flows currently active on this interface. A flow can be created ei- ther from a reservation protocol (such as RSVP or ST-II) or via conf… |
| 1.3.6.1.2.1.52.1.1.1.5 | ColumnintSrvIfAttribPropagationDelay | read-create | current | The amount of propagation delay that this in- terface introduces in addition to that intro- diced by bit propagation delays. |
| 1.3.6.1.2.1.52.1.1.1.6 | ColumnintSrvIfAttribStatus | read-create | current | 'active' on interfaces that are configured for RSVP. |
| 1.3.6.1.2.1.52.1.2 | TableintSrvFlowTable | not-accessible | current | Information describing the reserved flows us- ing the system's interfaces. |
| 1.3.6.1.2.1.52.1.2.1 | RowintSrvFlowEntry | not-accessible | current | Information describing the use of a given in- terface by a given flow. The counter intSrvFlowPoliced starts counting at the in- stallation of the flow. |
| 1.3.6.1.2.1.52.1.2.1.1 | ColumnintSrvFlowNumber | not-accessible | current | The number of this flow. This is for SNMP In- dexing purposes only and has no relation to any protocol value. |
| 1.3.6.1.2.1.52.1.2.1.2 | ColumnintSrvFlowType | read-create | current | The type of session (IP4, IP6, IP6 with flow information, etc). |
| 1.3.6.1.2.1.52.1.2.1.3 | ColumnintSrvFlowOwner | read-create | current | The process that installed this flow in the queue policy database. |
| 1.3.6.1.2.1.52.1.2.1.4 | ColumnintSrvFlowDestAddr | read-create | current | The destination address used by all senders in this session. This object may not be changed when the value of the RowStatus object is 'ac- tive'. |
| 1.3.6.1.2.1.52.1.2.1.5 | ColumnintSrvFlowSenderAddr | read-create | current | The source address of the sender selected by this reservation. The value of all zeroes in- dicates 'all senders'. This object may not be changed when the value… |
| 1.3.6.1.2.1.52.1.2.1.6 | ColumnintSrvFlowDestAddrLength | read-create | current | The length of the destination address in bits. This is the CIDR Prefix Length, which for IP4 hosts and multicast addresses is 32 bits. This object may not be c… |
| 1.3.6.1.2.1.52.1.2.1.7 | ColumnintSrvFlowSenderAddrLength | read-create | current | The length of the sender's address in bits. This is the CIDR Prefix Length, which for IP4 hosts and multicast addresses is 32 bits. This object may not be chan… |
| 1.3.6.1.2.1.52.1.2.1.8 | ColumnintSrvFlowProtocol | read-create | current | The IP Protocol used by a session. This ob- ject may not be changed when the value of the RowStatus object is 'active'. |
| 1.3.6.1.2.1.52.1.2.1.9 | ColumnintSrvFlowDestPort | read-create | current | The UDP or TCP port number used as a destina- tion port for all senders in this session. If the IP protocol in use, specified by intSrvResvFwdProtocol, is 50 (… |
| 1.3.6.1.2.1.52.1.2.1.10 | ColumnintSrvFlowPort | read-create | current | The UDP or TCP port number used as a source port for this sender in this session. If the IP protocol in use, specified by intSrvResvFwdProtocol is 50 (ESP) or … |
| 1.3.6.1.2.1.52.1.2.1.11 | ColumnintSrvFlowFlowId | read-only | current | The flow ID that this sender is using, if this is an IPv6 session. |
| 1.3.6.1.2.1.52.1.2.1.12 | ColumnintSrvFlowInterface | read-create | current | The ifIndex value of the interface on which this reservation exists. |
| 1.3.6.1.2.1.52.1.2.1.13 | ColumnintSrvFlowIfAddr | read-create | current | The IP Address on the ifEntry on which this reservation exists. This is present primarily to support those interfaces which layer multi- ple IP Addresses on th… |
| 1.3.6.1.2.1.52.1.2.1.14 | ColumnintSrvFlowRate | read-create | current | The Reserved Rate of the sender's data stream. If this is a Controlled Load service flow, this rate is derived from the Tspec rate parameter (r). If this is a … |
| 1.3.6.1.2.1.52.1.2.1.15 | ColumnintSrvFlowBurst | read-create | current | The size of the largest burst expected from the sender at a time. If this is less than the sender's advertised burst size, the receiver is asking the network t… |
| 1.3.6.1.2.1.52.1.2.1.16 | ColumnintSrvFlowWeight | read-create | current | The weight used to prioritize the traffic. Note that the interpretation of this object is implementation-specific, as implementations vary in their use of weig… |
| 1.3.6.1.2.1.52.1.2.1.17 | ColumnintSrvFlowQueue | read-create | current | The number of the queue used by this traffic. Note that the interpretation of this object is implementation-specific, as implementations vary in their use of q… |
| 1.3.6.1.2.1.52.1.2.1.18 | ColumnintSrvFlowMinTU | read-create | current | The minimum message size for this flow. The policing algorithm will treat smaller messages as though they are this size. |
| 1.3.6.1.2.1.52.1.2.1.19 | ColumnintSrvFlowMaxTU | read-create | current | The maximum datagram size for this flow that will conform to the traffic specification. This value cannot exceed the MTU of the interface. |
| 1.3.6.1.2.1.52.1.2.1.20 | ColumnintSrvFlowBestEffort | read-only | current | The number of packets that were remanded to best effort service. |
| 1.3.6.1.2.1.52.1.2.1.21 | ColumnintSrvFlowPoliced | read-only | current | The number of packets policed since the incep- tion of the flow's service. |
| 1.3.6.1.2.1.52.1.2.1.22 | ColumnintSrvFlowDiscard | read-create | current | If 'true', the flow is to incur loss when traffic is policed. If 'false', policed traff- ic is treated as best effort traffic. |
| 1.3.6.1.2.1.52.1.2.1.23 | ColumnintSrvFlowService | read-only | current | The QoS service being applied to this flow. |
| 1.3.6.1.2.1.52.1.2.1.24 | ColumnintSrvFlowOrder | read-create | current | In the event of ambiguity, the order in which the classifier should make its comparisons. The row with intSrvFlowOrder=0 is tried first, and comparisons procee… |
| 1.3.6.1.2.1.52.1.2.1.25 | ColumnintSrvFlowStatus | read-create | current | 'active' for all active flows. This object may be used to install static classifier infor- mation, delete classifier information, or au- thorize such. |
| 1.3.6.1.2.1.52.2 | NodeintSrvGenObjects | |||
| 1.3.6.1.2.1.52.2.1 | ScalarintSrvFlowNewIndex | read-write | current | This object is used to assign values to intSrvFlowNumber as described in 'Textual Con- ventions for SNMPv2'. The network manager reads the object, and then wri… |
| 1.3.6.1.2.1.52.3 | NodeintSrvNotifications | |||
| 1.3.6.1.2.1.52.4 | NodeintSrvConformance | |||
| 1.3.6.1.2.1.52.4.1 | NodeintSrvGroups | |||
| 1.3.6.1.2.1.52.4.1.1 | GroupintSrvIfAttribGroup | current | These objects are required for Systems sup- porting the Integrated Services Architecture. | |
| 1.3.6.1.2.1.52.4.1.2 | GroupintSrvFlowsGroup | current | These objects are required for Systems sup- porting the Integrated Services Architecture. | |
| 1.3.6.1.2.1.52.4.2 | NodeintSrvCompliances | |||
| 1.3.6.1.2.1.52.4.2.1 | ComplianceintSrvCompliance | read-only | current | The compliance statement |
Type Definitions
| Name | Syntax | Status | Description |
|---|---|---|---|
| BitRate | INTEGER (0..'7FFFFFFF'h) | current | The rate, in bits/second, that data may move in the context. Applicable contexts minimally include the speed of an interface or virtual circuit, the data rate of a (potentially aggre- gated) data flow, or the data rate … |
| BurstSize | INTEGER (0..'7FFFFFFF'h) | current | The number of octets of IP Data, including IP Headers, that a stream may send without concern for policing. |
| MessageSize | INTEGER (0..'7FFFFFFF'h) | current | The size of a message in bytes. This is used to specify the minimum and maximum size of a message along an integrated services route. |
| Port | OCTET STRING (SIZE(2..4)) | current | The value of the UDP or TCP Source or Destina- tion Port field, a virtual destination port or generalized port identifier used with the IPSEC Authentication Header or Encapsulating Security Payload, or other session dis… |
| Protocol | INTEGER (1..255) | current | The value of the IP Protocol field of an IP Datagram Header. This identifies the protocol layer above IP. For example, the value 6 is used for TCP and the value 17 is used for UDP. The values of this field are defined i… |
| QosService | INTEGER { bestEffort (1), guaranteedDelay (2), controlledLoad (5) } | current | The class of service in use by a flow. |
| SessionNumber | INTEGER (0..2147483647) | current | The Session Number convention is used for numbers identifying sessions or saved PATH or RESV information. It is a number in the range returned by a TestAndIncr variable, having no protocol meaning whatsoever but serving… |
| SessionType | INTEGER (1..255) | current | The value of the C-Type field of a Session ob- ject, as defined in the RSVP specification. This value determines the lengths of octet strings and use of certain objects such as the 'port' variables. If the C-Type calls … |