TPLINK-PORTCONFIG-MIB
12 objects
This MIB module contain a collection of managed objects for port configuration.
Imported Objects
| RFC1213-MIB | ifIndex |
| SNMPv2-SMI | MODULE-IDENTITY OBJECT-TYPE |
| SNMPv2-TC | DisplayString |
| TPLINK-MIB | tplinkMgmt |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.11863.6.8 | IdentitytplinkPortConfigMIB | This MIB module contain a collection of managed objects for port configuration. | ||
| 1.3.6.1.4.1.11863.6.8.1 | NodetplinkPortConfigMIBObjects | |||
| 1.3.6.1.4.1.11863.6.8.1.1 | TabletpPortConfigTable | not-accessible | current | A table that contains information about every port. You can configure the basic parameters for the ports. The parameters will affect the working mode of the po… |
| 1.3.6.1.4.1.11863.6.8.1.1.1 | RowtpPortConfigEntry | not-accessible | current | A list of information for each port of the device. |
| 1.3.6.1.4.1.11863.6.8.1.1.1.2 | ColumntpPortConfigDescription | read-write | current | This object indicate the description of the port. |
| 1.3.6.1.4.1.11863.6.8.1.1.1.3 | ColumntpPortConfigStatus | read-write | current | This object indicates the link status of the port. When enable is selected, the port can forward the packets normall. |
| 1.3.6.1.4.1.11863.6.8.1.1.1.4 | ColumntpPortConfigSpeed | read-write | current | This object indicates the speed and duplex mode of the port. The device connected to the switch should be in the same Speed and Duplex mode with the switch. Wh… |
| 1.3.6.1.4.1.11863.6.8.1.1.1.5 | ColumntpPortConfigDuplex | read-write | current | This object indicates the speed and duplex mode of the port. The device connected to the switch should be in the same Speed and Duplex mode with the switch. Wh… |
| 1.3.6.1.4.1.11863.6.8.1.1.1.6 | ColumntpPortConfigFlowCtrl | read-write | current | This object indicates the port status of the flow control. When Flow Control is enabled, the switch can synchronize the speed with its peer to avoid the packet… |
| 1.3.6.1.4.1.11863.6.8.1.1.1.7 | ColumntpPortConfigJumbo | read-write | current | This object indicates the port status of the jumbo. The default maximum transmission unit (MTU) size is 1518 bytes. When Jumbo is enabled, the MTU size is 9216… |
| 1.3.6.1.4.1.11863.6.8.1.1.1.8 | ColumntpPortConfigLAG | read-only | current | This object indicates the lag number of the port. |
| 1.3.6.1.4.1.11863.6.8.2 | NodetplinkPortConfigNotifications |