TUNNEL-MIB
42 objects
The MIB module for management of IP Tunnels, independent of the specific encapsulation scheme in use. Copyright (C) The Internet Society (2005). This version of this MIB module is part of RFC 4087; see the RFC itself for full legal notices.
Imported Objects
| IANAifType-MIB | IANAtunnelType |
| IF-MIB | ifIndex InterfaceIndexOrZero |
| INET-ADDRESS-MIB | InetAddress InetAddressType |
| IPV6-FLOW-LABEL-MIB | IPv6FlowLabelOrAny |
| SNMPv2-CONF | MODULE-COMPLIANCE OBJECT-GROUP |
| SNMPv2-SMI | Integer32 IpAddress MODULE-IDENTITY OBJECT-TYPE transmission |
| SNMPv2-TC | RowStatus StorageType |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.2.1.10.131 | IdentitytunnelMIB | The MIB module for management of IP Tunnels, independent of the specific encapsulation scheme in use. Copyright (C) The Internet Society (2005). This version o… | ||
| 1.3.6.1.2.1.10.131.1 | NodetunnelMIBObjects | |||
| 1.3.6.1.2.1.10.131.1.1 | Nodetunnel | |||
| 1.3.6.1.2.1.10.131.1.1.1 | TabletunnelIfTable | not-accessible | current | The (conceptual) table containing information on configured tunnels. |
| 1.3.6.1.2.1.10.131.1.1.1.1 | RowtunnelIfEntry | not-accessible | current | An entry (conceptual row) containing the information on a particular configured tunnel. |
| 1.3.6.1.2.1.10.131.1.1.1.1.1 | ColumntunnelIfLocalAddress | read-only | deprecated | The address of the local endpoint of the tunnel (i.e., the source address used in the outer IP header), or 0.0.0.0 if unknown or if the tunnel is over IPv6. Si… |
| 1.3.6.1.2.1.10.131.1.1.1.1.2 | ColumntunnelIfRemoteAddress | read-only | deprecated | The address of the remote endpoint of the tunnel (i.e., the destination address used in the outer IP header), or 0.0.0.0 if unknown, or an IPv6 address, or the… |
| 1.3.6.1.2.1.10.131.1.1.1.1.3 | ColumntunnelIfEncapsMethod | read-only | current | The encapsulation method used by the tunnel. |
| 1.3.6.1.2.1.10.131.1.1.1.1.4 | ColumntunnelIfHopLimit | read-write | current | The IPv4 TTL or IPv6 Hop Limit to use in the outer IP header. A value of 0 indicates that the value is copied from the payload's header. |
| 1.3.6.1.2.1.10.131.1.1.1.1.5 | ColumntunnelIfSecurity | read-only | current | The method used by the tunnel to secure the outer IP header. The value ipsec indicates that IPsec is used between the tunnel endpoints for authentication or en… |
| 1.3.6.1.2.1.10.131.1.1.1.1.6 | ColumntunnelIfTOS | read-write | current | The method used to set the high 6 bits (the differentiated services codepoint) of the IPv4 TOS or IPv6 Traffic Class in the outer IP header. A value of -1 indi… |
| 1.3.6.1.2.1.10.131.1.1.1.1.7 | ColumntunnelIfFlowLabel | read-write | current | The method used to set the IPv6 Flow Label value. This object need not be present in rows where tunnelIfAddressType indicates the tunnel is not over IPv6. A va… |
| 1.3.6.1.2.1.10.131.1.1.1.1.8 | ColumntunnelIfAddressType | read-write | current | The type of address in the corresponding tunnelIfLocalInetAddress and tunnelIfRemoteInetAddress objects. |
| 1.3.6.1.2.1.10.131.1.1.1.1.9 | ColumntunnelIfLocalInetAddress | read-write | current | The address of the local endpoint of the tunnel (i.e., the source address used in the outer IP header). If the address is unknown, the value is 0.0.0.0 for IPv… |
| 1.3.6.1.2.1.10.131.1.1.1.1.10 | ColumntunnelIfRemoteInetAddress | read-write | current | The address of the remote endpoint of the tunnel (i.e., the destination address used in the outer IP header). If the address is unknown or the tunnel is not a … |
| 1.3.6.1.2.1.10.131.1.1.1.1.11 | ColumntunnelIfEncapsLimit | read-write | current | The maximum number of additional encapsulations permitted for packets undergoing encapsulation at this node. A value of -1 indicates that no limit is present (… |
| 1.3.6.1.2.1.10.131.1.1.2 | TabletunnelConfigTable | not-accessible | deprecated | The (conceptual) table containing information on configured tunnels. This table can be used to map a set of tunnel endpoints to the associated ifIndex value. I… |
| 1.3.6.1.2.1.10.131.1.1.2.1 | RowtunnelConfigEntry | not-accessible | deprecated | An entry (conceptual row) containing the information on a particular configured tunnel. Since this entry does not support IPv6, it is deprecated in favor of tu… |
| 1.3.6.1.2.1.10.131.1.1.2.1.1 | ColumntunnelConfigLocalAddress | not-accessible | deprecated | The address of the local endpoint of the tunnel, or 0.0.0.0 if the device is free to choose any of its addresses at tunnel establishment time. Since this objec… |
| 1.3.6.1.2.1.10.131.1.1.2.1.2 | ColumntunnelConfigRemoteAddress | not-accessible | deprecated | The address of the remote endpoint of the tunnel. Since this object does not support IPv6, it is deprecated in favor of tunnelInetConfigRemoteAddress. |
| 1.3.6.1.2.1.10.131.1.1.2.1.3 | ColumntunnelConfigEncapsMethod | not-accessible | deprecated | The encapsulation method used by the tunnel. Since this object does not support IPv6, it is deprecated in favor of tunnelInetConfigEncapsMethod. |
| 1.3.6.1.2.1.10.131.1.1.2.1.4 | ColumntunnelConfigID | not-accessible | deprecated | An identifier used to distinguish between multiple tunnels of the same encapsulation method, with the same endpoints. If the encapsulation protocol only allows… |
| 1.3.6.1.2.1.10.131.1.1.2.1.5 | ColumntunnelConfigIfIndex | read-only | deprecated | If the value of tunnelConfigStatus for this row is active, then this object contains the value of ifIndex corresponding to the tunnel interface. A value of 0 i… |
| 1.3.6.1.2.1.10.131.1.1.2.1.6 | ColumntunnelConfigStatus | read-create | deprecated | The status of this row, by which new entries may be created, or old entries deleted from this table. The agent need not support setting this object to createAn… |
| 1.3.6.1.2.1.10.131.1.1.3 | TabletunnelInetConfigTable | not-accessible | current | The (conceptual) table containing information on configured tunnels. This table can be used to map a set of tunnel endpoints to the associated ifIndex value. I… |
| 1.3.6.1.2.1.10.131.1.1.3.1 | RowtunnelInetConfigEntry | not-accessible | current | An entry (conceptual row) containing the information on a particular configured tunnel. Note that there is a 128 subid maximum for object OIDs. Implementers ne… |
| 1.3.6.1.2.1.10.131.1.1.3.1.1 | ColumntunnelInetConfigAddressType | not-accessible | current | The address type over which the tunnel encapsulates packets. |
| 1.3.6.1.2.1.10.131.1.1.3.1.2 | ColumntunnelInetConfigLocalAddress | not-accessible | current | The address of the local endpoint of the tunnel, or 0.0.0.0 (for IPv4) or :: (for IPv6) if the device is free to choose any of its addresses at tunnel establis… |
| 1.3.6.1.2.1.10.131.1.1.3.1.3 | ColumntunnelInetConfigRemoteAddress | not-accessible | current | The address of the remote endpoint of the tunnel. |
| 1.3.6.1.2.1.10.131.1.1.3.1.4 | ColumntunnelInetConfigEncapsMethod | not-accessible | current | The encapsulation method used by the tunnel. |
| 1.3.6.1.2.1.10.131.1.1.3.1.5 | ColumntunnelInetConfigID | not-accessible | current | An identifier used to distinguish between multiple tunnels of the same encapsulation method, with the same endpoints. If the encapsulation protocol only allows… |
| 1.3.6.1.2.1.10.131.1.1.3.1.6 | ColumntunnelInetConfigIfIndex | read-only | current | If the value of tunnelInetConfigStatus for this row is active, then this object contains the value of ifIndex corresponding to the tunnel interface. A value of… |
| 1.3.6.1.2.1.10.131.1.1.3.1.7 | ColumntunnelInetConfigStatus | read-create | current | The status of this row, by which new entries may be created, or old entries deleted from this table. The agent need not support setting this object to createAn… |
| 1.3.6.1.2.1.10.131.1.1.3.1.8 | ColumntunnelInetConfigStorageType | read-create | current | The storage type of this row. If the row is permanent(4), no objects in the row need be writable. |
| 1.3.6.1.2.1.10.131.2 | NodetunnelMIBConformance | |||
| 1.3.6.1.2.1.10.131.2.1 | NodetunnelMIBCompliances | |||
| 1.3.6.1.2.1.10.131.2.1.1 | CompliancetunnelMIBCompliance | read-only | deprecated | The (deprecated) IPv4-only compliance statement for the IP Tunnel MIB. This is deprecated in favor of tunnelMIBInetFullCompliance and tunnelMIBInetReadOnlyComp… |
| 1.3.6.1.2.1.10.131.2.1.2 | CompliancetunnelMIBInetFullCompliance | current | The full compliance statement for the IP Tunnel MIB. | |
| 1.3.6.1.2.1.10.131.2.1.3 | CompliancetunnelMIBInetReadOnlyCompliance | read-only | current | The read-only compliance statement for the IP Tunnel MIB. |
| 1.3.6.1.2.1.10.131.2.2 | NodetunnelMIBGroups | |||
| 1.3.6.1.2.1.10.131.2.2.1 | GrouptunnelMIBBasicGroup | deprecated | A collection of objects to support basic management of IPv4 Tunnels. Since this group cannot support IPv6, it is deprecated in favor of tunnelMIBInetGroup. | |
| 1.3.6.1.2.1.10.131.2.2.2 | GrouptunnelMIBInetGroup | current | A collection of objects to support basic management of IPv4 and IPv6 Tunnels. |