aluRS232Speed specifies the link speed of the Serial interface. A value of 'speed1200' sets the link to 1200bps. A value of 'speed64k' sets the link to 64kbps. Valid values depend on tmnxMDAAssignedType : sdiv1 : 600, 1200, 2400, 4800, 9600, 19200, 38400, 56000, 64k, 128k, 256k, 384k, 512k, 640k, 768k, 896k, 1024k, 1152k, 1280k, 1408k, 1536k, 1664k, 1792k, 1920k sdiv2 : 600, 1200, 2400, 4800, 9600, 19200, 38400, 56000, 57600, 115200 64k, 128k, 256k, 384k, 512k, 640k, 768k, 896k, 1024k, 1152k, 1280k, 1408k, 1536k, 1664k, 1792k, 1920k sdiv3 : <all speeds> On the SAR-H and SAR-Hc systems, valid values are the same as sdiv2. Valid values also depend on aluRS232Type : rs232 : 600, 1200, 2400, 4800, 9600, 16000, 19200, 38400, 56000, 57600, 115200 64k (sdiv3 only) v35 : 64k, 128k, 256k, 384k, 512k, 640k, 768k, 896k, 1024k, 1152k, 1280k, 1408k, 1536k, 1664k, 1792k, 1920k, 2048k x21 : 1200, 2400, 4800, 9600, 19200, 38400, 56000, 64k, 128k, 256k, 384k, 512k, 640k, 768k, 896k, 1024k, 1152k, 1280k, 1408k, 1536k, 1664k, 1792k, 1920k, 2048k rs530 : <all speeds except 57600 and 115200> Valid values also depend on aluRS232DeviceMode : synchronous : <all speeds except 57600 and 115200> asynchronous : 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 Valid values also depend on the sub-channel: (none) : <no additional restrictions> aluRS232ChanGroupEntry : <all speeds except 57600 and 115200> aluRS232SocketEntry : <asynchronous speeds only> High Capacity Multiplexing (HCM) is supported on aluRS232ChanGroupEntry only, running at subrate speed: hcm : 600, 1200, 2400, 4800, 9600, 16000, 19200, 38400, 56000 Valid values also depend on aluRS232ControlLeadXxx : high : <no additional restrictions> low : <no additional restrictions> end-to-end : <HCM speeds only; rs530 exempt> Valid values also depend on aluRS232MultiDrop : disabled : <no additional restrictions> slave : <HCM speeds only> master : <HCM speeds only> Default values depend on aluRS232Type : rs232 : 9600 v35 : 64k x21 : 64k rs530 : 64k