Status bitmap: Bit 0: bit 0 is set if and only if none of the other bits is set. Bit 1: bit 1 set indicates that persistent data has been lost including data necessary to establish OAM connectivity. Bit 2: bit 2 set indicates that persistent data has been lost but not including data necessary to establish OAM connectivity. Bit 3: bit 3 set indicates that a power-on reset has occured. Notice that this also means that all reset-safe data has been lost. Bit 4: bit 4 set indicates that a reset other than a power-on reset has occured. Bit 5: not used anymore. Bit 6: this bit indicates that alarm 'SHub configuration loss' (EQUIP alarm nbr 28) was raised. The purpose of using this bit is to clear this alarm by using asamSysStatusClearBitMap. Bit 7: this bit indicates that one or several 'xVPS configuration loss' alarms (PlugInUnit2 alarm nbr 11) were raised. The purpose of using this bit is to clear the alarms by using asamSysStatusClearBitMap. Bit 8: this bit indicates that alarm 'Invalid xVPS Pair Redundancy Data' (LSM Redundancy 131 nbr 2) was raised. The purpose of using this bit is to clear this alarm by using asamSysStatusClearBitMap. Bit 9 .. 31 : reserved for future extensions. ALCATEL NOTE: SUPPORT: YES INSRVMOD: NA RANGE: 1..4294967295 PERSIST: YES DEFVALUE: NA UNITS: -