The operation that should be applied to a packet in case the packet does not match any of the user specified rules. Values pertains to ACL or QoS depending on List type. This field points to the appropriate ipPolicyCompositeOpID in ipPolicyCompositeOpTable. The following read-only rows that are always defined in ipPolicyCompositeOpTable for a combined List: OpId OpName PolicyRuleOp prior to Policy MIB 1.3.0 ==== ====== ====================================== 1 Priority 0 forwardPriority0(1) 2 Priority 1 forwardPriority1(2) 3 Priority 2 forwardPriority2(3) 4 Priority 3 forwardPriority3(4) 5 Priority 4 forwardPriority4(5) 6 Priority 5 forwardPriority5(6) 7 Priority 6 forwardPriority6(7) 8 Priority 7 forwardPriority7(8) 9 Forward No Change forward(9) 10 Deny deny(10) 11 Deny and Notify denyAndNotify(11) 12 Do not EZRoute layer2Switching(12) The following read-only rows that are always defined in ipPolicyCompositeOpTable for list in split list mode: OpId OpName ==== ====== 1 permit 2 deny 3 deny-and-notify 4 deny-and-reset-connection (Boxster only) 5 deny-and-notify-and-reset-connection (Boxster only) The following read-only rows that are always defined in ipPolicyCompositeOpTable for a ACL list in split list mode: OpId OpName ==== ====== 1 CoS0 2 CoS1 3 CoS2 4 CoS3 5 CoS4 6. CoS5 7. CoS6 8. CoS7 9. no-change 10. trust-dscp-only 11. trust-dscp-and-cos (Boxster default) The following read-only rows are always defined in ipPolicyCompositeOpTable for PBR list in split list mode: OpId OpName ==== ====== 1 DBR (Destination Based Routing) 2 unused . . 9 NH1 (Next Hop) 10 NH2 . . 28 NH20 The following read-only rows are always defined in ipPolicyCompositeOpTable for Crypto list in split list mode: OpId OpName ==== ====== 1 Bypass 2 Crypto Map 1 3 Crypto Map 2 21 Crypto Map 20 Access-control default operation is permit. QoS default operation is no-change. PBR default operation is DBR (Destination Based Routing). Zydeco uses combined list with additional two actions. Actions' access is permits. QoS is defined below: 13: Change 802.1p based on DSCP - change 802.1p value based on packet's DSCP (MIB wise: uses DSCP table to further DSCP based classification) 14: Change DSCP based on 5-tuple - change DSCP value (MIB wise: ipPolicyRuleDSCPOperation indicates the new DSCP value)