The value of tmnxOamPmCfgThrDelayRaise specifies the OAM-PM raise threshold for excessive delay. For example, suppose: 1. tmnxOamPmCfgThrDelayRaise=1000 and tmnxOamPmCfgThrDelayLowestBin=7 for the index values 255, 'ifdv(3)', 'twoWay(3)'. 2. Bin group 255 has been configured with 10 Inter-Frame Delay Variation (IFDV) bins (numbered 0..9), using tmnxOamPmCfgBinGroupIfdvBinCount. 3. The OAM-PM session 'oamPmSession1' is configured to use bin group 255 (using tmnxOamPmCfgSessBinGroupId). 4. OAM-PM delay TCAs are enabled for the measurement interval with indices 'oamPmSession1', 'mi15Minutes(2)' (using tmnxOamPmCfgMeasIntvlDelayTCAs and tmnxOamPmCfgMeasIntvlTCAs). 5. During a 15 minute interval belonging to a DMM test which belongs to 'oamPmSession1', the following inequality becomes true (where only the last two indices of the object are shown, and the last index is a bin number): tmnxOamPmStsDelayDmmBin2wyCount.ifdv(3).7 + tmnxOamPmStsDelayDmmBin2wyCount.ifdv(3).8 + tmnxOamPmStsDelayDmmBin2wyCount.ifdv(3).9 >= 1000 Then, a delay Raise TCA (using tmnxOamPmThrRaise) will be generated immediately. The TCA suppression and configuration rules for tmnxOamPmCfgThrDelayRaise and tmnxOamPmCfgThrDelayClear are the same as the rules for tmnxOamPmCfgThrLossChliRaise and tmnxOamPmCfgThrLossChliClear. The upper bound of this object is the maximum number of DMM PDUs (or TWAMP-Test PDUs) which can be sent in the longest supported (i.e. 24 hour) measurement interval.