The value of tmnxOamPmCfgThrLossChliRaise specifies the raise threshold for Consecutive High Loss Intervals (CHLIs). Depending on the specified indices, tmnxOamPmCfgThrLossChliRaise is the raise threshold for: tmnxOamPmStsLossLmmChliBwd, tmnxOamPmStsLossLmmChliFwd + tmnxOamPmStsLossLmmChliBwd, tmnxOamPmStsLossLmmChliFwd, tmnxOamPmStsLossSlmChliBwd, tmnxOamPmStsLossSlmChliFwd + tmnxOamPmStsLossSlmChliBwd, tmnxOamPmStsLossSlmChliFwd, tmnxOamPmStsLossTwlChliBwd, tmnxOamPmStsLossTwlChliFwd + tmnxOamPmStsLossTwlChliBwd, or tmnxOamPmStsLossTwlChliFwd. For example, suppose: 1. OAM-PM loss TCAs are enabled for the 'mi15minutes(2)' measurement interval of the OAM-PM session OAM_PM_Eth_session_1 (using tmnxOamPmCfgMeasIntvlLossTCAs and tmnxOamPmCfgMeasIntvlTCAs). 2. tmnxOamPmCfgThrLossChliRaise is set to 7 for the indices {OAM_PM_Eth_session_1, 'slm(2)', 'forward(1)'}. 3. A 15 minute interval belonging to OAM_PM_Eth_session_1's SLM test has its forward CHLI count (i.e. tmnxOamPmStsLossSlmChliFwd) increase to 7. 4. Generating a CHLI Raise TCA is allowed (e.g. the most recent CHLI TCA for the specified indices was a Clear). Then, SROS immediately generates a CHLI Raise TCA (using tmnxOamPmThrRaise) for the 15-minute interval, for the forward direction. Negative one specifies that CHLI thresholding is disabled for the specified indices (i.e. SROS will not generate a Raise TCA, or a Clear TCA). tmnxOamPmCfgThrLossChliRaise must be greater than tmnxOamPmCfgThrLossChliClear. Exception: the combination tmnxOamPmCfgThrLossChliRaise=-1 and tmnxOamPmCfgThrLossChliClear=-1 is supported. tmnxOamPmCfgThrLossChliRaise and tmnxOamPmCfgThrLossChliClear must be set in the same SNMP Set PDU. The upper bound of this object is the maximum number of MEF-35 'delta_t' time intervals (also known as 'Small Time Intervals') which can occur in a 24 hour measurement interval.