MIB Viewer

CISCO-IP-TAP-MIB

28 objects
This module manages Cisco's intercept feature for IP. This MIB is used along with CISCO-TAP2-MIB to intercept IP traffic. CISCO-TAP2-MIB along with specific filter MIBs like this MIB replace CISCO-TAP-MIB. To create an IP intercept, an entry citapStreamEntry is created which contains the filter details. An entry cTap2StreamEntry of CISCO-TAP2-MIB is created, which is the common stream information for all kinds of intercepts and type of the specific stream is set to ip in this entry.
Imported Objects
CISCO-SMIciscoMgmt
CISCO-TAP2-MIBcTap2MediationContentId cTap2StreamIndex
INET-ADDRESS-MIBInetAddress InetAddressPrefixLength InetAddressType InetPortNumber
SNMP-FRAMEWORK-MIBSnmpAdminString
SNMPv2-CONFMODULE-COMPLIANCE OBJECT-GROUP
SNMPv2-SMIInteger32 MODULE-IDENTITY OBJECT-TYPE
SNMPv2-TCRowStatus
OIDNameAccessStatusDescription
1.3.6.1.4.1.9.9.394IdentityciscoIpTapMIBThis module manages Cisco's intercept feature for IP. This MIB is used along with CISCO-TAP2-MIB to intercept IP traffic. CISCO-TAP2-MIB along with specific fi…
1.3.6.1.4.1.9.9.394.0NodeciscoIpTapMIBNotifs
1.3.6.1.4.1.9.9.394.1NodeciscoIpTapMIBObjects
1.3.6.1.4.1.9.9.394.1.1NodecitapStreamEncodePacket
1.3.6.1.4.1.9.9.394.1.1.1ScalarcitapStreamCapabilitiesread-onlycurrentThis object displays what types of intercept streams can be configured on this type of device. This may be dependent on hardware capabilities, software capabil…
1.3.6.1.4.1.9.9.394.1.1.2TablecitapStreamTablenot-accessiblecurrentThe Intercept Stream IP Table lists the IPv4 and IPv6 streams to be intercepted. The same data stream may be required by multiple taps, and one might assume th…
1.3.6.1.4.1.9.9.394.1.1.2.1RowcitapStreamEntrynot-accessiblecurrentA stream entry indicates a single data stream to be intercepted to a Mediation Device. Many selected data streams may go to the same application interface, and…
1.3.6.1.4.1.9.9.394.1.1.2.1.1ColumncitapStreamInterfaceread-createcurrentThe ifIndex value of the interface over which traffic to be intercepted is received or transmitted. The interface may be physical or virtual. If this is the on…
1.3.6.1.4.1.9.9.394.1.1.2.1.2ColumncitapStreamAddrTyperead-createcurrentThe type of address, used in packet selection.
1.3.6.1.4.1.9.9.394.1.1.2.1.3ColumncitapStreamDestinationAddressread-createcurrentThe Destination address or prefix used in packet selection. This address will be of the type specified in citapStreamAddrType.
1.3.6.1.4.1.9.9.394.1.1.2.1.4ColumncitapStreamDestinationLengthread-createcurrentThe length of the Destination Prefix. A value of zero causes all addresses to match. This prefix length will be consistent with the type specified in citapStre…
1.3.6.1.4.1.9.9.394.1.1.2.1.5ColumncitapStreamSourceAddressread-createcurrentThe Source Address used in packet selection. This address will be of the type specified in citapStreamAddrType.
1.3.6.1.4.1.9.9.394.1.1.2.1.6ColumncitapStreamSourceLengthread-createcurrentThe length of the Source Prefix. A value of zero causes all addresses to match. This prefix length will be consistent with the type specified in citapStreamAdd…
1.3.6.1.4.1.9.9.394.1.1.2.1.7ColumncitapStreamTosByteread-createcurrentThe value of the TOS byte, when masked with citapStreamTosByteMask, of traffic to be intercepted. If citapStreamTosByte&(~citapStreamTosByteMask)!=0, configura…
1.3.6.1.4.1.9.9.394.1.1.2.1.8ColumncitapStreamTosByteMaskread-createcurrentThe value of the TOS byte in an IPv4 or IPv6 header is ANDed with citapStreamTosByteMask and compared with citapStreamTosByte. If the values are equal, the com…
1.3.6.1.4.1.9.9.394.1.1.2.1.9ColumncitapStreamFlowIdread-createcurrentThe flow identifier in an IPv6 header. -1 indicates that the Flow Id is unused.
1.3.6.1.4.1.9.9.394.1.1.2.1.10ColumncitapStreamProtocolread-createcurrentThe IP protocol to match against the IPv4 protocol number or the IPv6 Next- Header number in the packet. -1 means 'any IP protocol'.
1.3.6.1.4.1.9.9.394.1.1.2.1.11ColumncitapStreamDestL4PortMinread-createcurrentThe minimum value that the layer-4 destination port number in the packet must have in order to match. This value must be equal to or less than the value specif…
1.3.6.1.4.1.9.9.394.1.1.2.1.12ColumncitapStreamDestL4PortMaxread-createcurrentThe maximum value that the layer-4 destination port number in the packet must have in order to match this classifier entry. This value must be equal to or grea…
1.3.6.1.4.1.9.9.394.1.1.2.1.13ColumncitapStreamSourceL4PortMinread-createcurrentThe minimum value that the layer-4 destination port number in the packet must have in order to match. This value must be equal to or less than the value specif…
1.3.6.1.4.1.9.9.394.1.1.2.1.14ColumncitapStreamSourceL4PortMaxread-createcurrentThe maximum value that the layer-4 destination port number in the packet must have in order to match this classifier entry. This value must be equal to or grea…
1.3.6.1.4.1.9.9.394.1.1.2.1.15ColumncitapStreamVRFread-createcurrentAn ASCII string, which is the name of a Virtual Routing and Forwarding (VRF) table comprising the routing context of a Virtual Private Network. The interface o…
1.3.6.1.4.1.9.9.394.1.1.2.1.16ColumncitapStreamStatusread-createcurrentThe status of this conceptual row. This object manages creation, modification, and deletion of rows in this table. When any rows must be changed, citapStreamSt…
1.3.6.1.4.1.9.9.394.2NodeciscoIpTapMIBConform
1.3.6.1.4.1.9.9.394.2.1NodeciscoIpTapMIBCompliances
1.3.6.1.4.1.9.9.394.2.1.1ComplianceciscoIpTapMIBCompliancecurrentThe compliance statement for entities which implement the Cisco Intercept MIB for IP.
1.3.6.1.4.1.9.9.394.2.2NodeciscoIpTapMIBGroups
1.3.6.1.4.1.9.9.394.2.2.1GroupciscoIpTapStreamComplianceGroupcurrentThese objects are necessary for a description of IPv4 and IPv6 packets to select for interception.
MIB Viewer