The Frame Relay Group provisioning and status table entry. To create a frame relay group, the following procedures are used: (1) The management application creates Frame Relay Group entry in the adGenFrGroupTable by setting the adGenFrGroupRowStatus to createAndWait(5). This may fail for the following reasons which are reported through the adGenFrSlotGroupLastCreateError object: - The selected ifIndex specifies an invalid interface - The selected ifIndex is already in use by another Frame Relay Group Otherwise, upon successful creation of the row, the group is reserved and a corresponding row (identical ifIndex) in the frMgtVcSigTable is created. (2) The manager sets other provisioning rows in the adGenFrGroupTable and the frMgtVCSigTable that are appropriate for the service that is to be provided. (3) Connect a frame relay link to the group to specify which interface is to provide service to the group. See the adGenFrLinkTable description for more information. (4) If no detectable errors or conflicts in the group provisioning is detected, the adGenFrSlotGroupLastCreateError object will contain an empty (zero length) string and and can be enabled by setting adGenFrGroupRowStatus to active(1). (*) Signaling errors (if enabled) and any provisioning failures after setting the adGenFrGroupRowStatus to active(1) can be detected by examining the ifTable's ifOperStatus object. If this value is not up(1), the adGenFrSlotGroupLastCreateError object will contain further diagnostic information as to the cause of any failure.