This parameter is used to set the operating mode of the output. Operating mode changes can only occur when the output is not in use (no service, PID, or stream mapping active to the output). Session Control - User must select either RTSP or RPC to communicate with external resource manager. All service mappings on output are controlled by the external manager. - Only valid when Encryption Type is set to CTE or None - If 'apexEncryptionConfAlgorithm' is set to dvb-csa-simulcrypt, then it is valid only when Simulcrypt Mode is set to None. - PID Remapping mode should be Enabled (Without Reuse) Manual Routing - User manually maps each service - Encryption Type can be any valid setting (none, CTE, or Broadcast) - Simulcrypt Mode must be None or External EIS UDP Port Mapping - Standard UDP Port Mapping for use with VOD servers. Uses specific algorithm based on UDP Port to determine output program mappings. - Encryption Type must be None or CTE (broadcast not supported) - Simulcrypt Mode must be None or External EIS Operating mode changes can only occur when the output is not in use (no service, PID, or stream mapping active to the output). @Commit(param=apexOutputTsConfApplyChange, value=2)