Configures how the APEX is connected to the REM1000. 'none' - Not connecting to REM1000. 'direct' - Connected to REM1000 dedicated IP interface through APEX Data IP (Enet2). Broadcast connection is always used in this case. Cannot be set to 'direct' if the QAM RF Redundancy UDP Port is in use on the Data IP Port (Enet2). QAM RF Redundancy UDP Port value is found in apexQamRfRedundStatusUdpPort. 'common' - Connected to REM1000 OAM&P interface through APEX OAM&P IP (Enet 1). Requires user to configure REM1000 IP address in apexQamRfRedundConfigRemCommonIpAddr. Cannot be set to 'common' if the QAM RF Redundancy UDP Port is in use on the OAM&P IP (Enet 1). QAM RF Redundancy UDP Port value is found in apexQamRfRedundStatusUdpPort. Once written, the change to this parameter will only take immediate effect after apexQamRfRedundConfigApplyChange is set to 'apply'. In order for the change to persist through subsequent reboots or power cycles, the change must be saved via the apexSaveConfig parameter. @Config(config=yes, reboot=no) @Commit(param=apexQamRfRedundConfigApplyChange, value=2) @Save(apexSaveConfig, value=2) @File(config.ini, type='ini')