A read on this object can return several possible values, depending on the current status of the system and the various file operation objects: idle There is no file operation in progress and all required objects have been set correctly. Setting a '1' to this object will begin the file copy. Error codes: [1-7] A copy operation cannot be started until these errors are resolved. See below for key. [action]ing x [ currently in progress. You cannot start another operation while the object is returning this value. [action] x [ delete operation was successfully completed. [action] x [ delete operation failed, with the error message attached. Common failures include lack of space on the destination file system, incorrect source file names or communication errors with remote services. Upon reading a success or failure message, the message will be cleared and the next read will result in either an 'idle' message or an 'Error codes' message if not all required objects have been correctly set. If the read returned 'idle', a new file operation can now be started. Error codes for file copy: 1 - atFilev2SourceDevice has not been set 2 - atFilev2SourceFilename has not been set 3 - atFilev2DestinationDevice has not been set 4 - atFilev2DestinationFilename has not been set 5 - atFilev2SourceDevice and atFilev2DestinationDevice are both set to TFTP 6 - the combination of source device, stackID and filename is the same as the destination device, stackID and filename (i.e. it is not valid to copy a file onto itself. 7 - TFTP IP address has not been set and TFTP has been set for one of the devices Provided all above requirements are met, immediately upon executing the SNMP set, the device will indicate that it was a success. The actual file copy itself will be started and continue on the device until it has completed. For large files, operations can take several minutes to complete. Subsequent reads of the object will return one of messages shown in the first table, to allow for tracking of the progress of the copy operation.