This table provides the ability to remap all frames from one port onto another port. A port is defined by ctIFRemap2PortIndex from the ctIFRemap2PortTable below. Only ports listed in the ctIFRemap2PortTable are available for remapping. A given source port may only be mapped to only one destination port. Once a port is reserved as part of a ctIFRemap2Table entry, it may not be used in any other ctIFRemap2Table entries (ie. If remapping port 1 to port 3, then neither port 1 or port 3 may be used as a ctIFRemap2SourcePort or ctIFRemap2DestPort in another ctIFRemap2Table entry). Each row that exists in this table defines such a relationship. By disabling a row in this table the remapping relationship no longer exists. Each entry will be referenced by slot. In the case of a stand-alone device the slot will always be 1. If a given relationship cannot be created the set will fail with a BAD-VALUE error.