Test status. Options: 1: startSuccessfully(1) -indicates Start test successfully (the EMS can activate or loop back a port without starting the test) 2: stopSuccessfully(2) -indicates Stop test successfully 3: testingNormal(3) -indicates Test normal 4: actUIfouttime(4) -indicates Timed-out (activating the U interface) 5: dslDeactOrCancelLoop(5) -indicates Deactivate the DSL report/cancel loopback1 (the EMS may receive this message when the EMS does not deliver the activate or loopback command) 6: actUIfFailed(6) -indicates Activating the U interface fails 7: normalMasterPowerAbnormalStandbyPowerAbnormal(7)-indicates Normal, the primary power does not work, and the standby power does not work 8: normalMasterPowerNormalStandbyPowerAbnormal(8) -indicates Normal, the primary power works, and the standby power does not work 9: normalMasterPowerAbNormalStandbyPowerNormal(9) -indicates Normal, the primary power does not work, and the standby power works 10: normalMasterPowerNormalStandbyPowerNormal(10) -indicates Normal, the primary power works, and the standby power works; 11: singleTestingOutTime(11) -indicates Timed-out (a single test) 12: singleTestingFailure(12) -indicates A single test fails 13: outtime(13) -indicates Timed-out (test) 14: dslReportFailure(14) -indicates DSL report fails; 15: notTesting(15) -indicates Not tested 16: testingAbnormal(16) -indicates Test abnormal