MIB Viewer

Search, upload, browse, or download from a database of over 11,000 SNMP MIBs. MIB Viewer lets you look up any MIB object by name, OID, or number, view its syntax, access level, and description, trace its place in the MIB tree, and generate ready-to-run SNMP commands — all in your browser.

What's a MIB?

A MIB (Management Information Base) is a structured document that defines the data a device exposes over SNMP — things like interface counters, system uptime, or CPU load. Each module declares a set of named objects, organized into a tree.

What's SNMP?

SNMP (Simple Network Management Protocol) is how network devices — routers, switches, servers — report status and statistics to monitoring tools. It's the protocol; MIBs are the vocabulary it uses to describe what's being asked for.

What's an OID?

An OID (Object Identifier) is the numeric address of one piece of data in a MIB — a dotted sequence like 1.3.6.1.2.1.1.1, read from the root of a global tree down to one specific object. Names are easier to read; OIDs are what's actually sent over the wire.

Try it: sysDescr (1.3.6.1.2.1.1.1) →

Get started

Search for a MIB or OID above, or pick one from the list on the left.

Have your own MIB file? Drop it on the upload zone in the sidebar (or click to browse) to parse and explore it right away — it stays private to this browser session and isn't added to the shared library.

iso/org/dod/internet/private/enterprises/.1429/.79/saRg/.3/saRgIpMgmtLanTable/saRgIpMgmtLanEntry/saRgIpMgmtLanMode

saRgIpMgmtLanMode

OBJECT-TYPE

1.3.6.1.4.1.1429.79.2.3.2.1.1

Access

read-write

Status

current

Source

SA-RG-MIB

Sub-identifiers

Description

Defines the mode of operation for the device. Setting this object via SNMP for the primary BSS will cause the unit to reboot. Setting this object via SNMP for the secondary BSSs will not cause the unit to reboot. The value for primary BSS is stored in non-vol and is router after factory reset. The default value for other BSSs is router. This MIB supersedes saRgDeviceMode for the .32 interface. l2tpv2-client(3)is obsoleted and NOT supported. bridge(1): Sets individual interface to bridging mode (for IPv6 interfaces DHCPv6 is external) router(2): Sets individual interface to routing mode (for IPv6 interfaces DHCPv6 is internal) l2tpv2-client(3): <obsolete> mixed(4): For mixed mode. This setting is applicable only to .32 interface. This value is used on conjunction with saRgIpMgmtLanPortControlTable *Note: mixed(4) mode NOT Supported by DOCSIS 2.0 products. vlan (5): Enables the vlan control feature. See saRgVlanTable MIBs for VLAN configuration information.

Syntax

INTEGER { bridge(1), router(2), l2tpv2-client(3), mixed(4), vlan(5) }