Type of output which is connected to water cool unit to output[waterCoolUnitOutputIndex] 1: no output connected 2: output failure 3: value overflow 4: water valve setpoint 5: water valve hysteresis 6: command for manual control 7: Flow Meter Model, 0=SIKA, 1=Chemline 8: minimum fan speed 9: min delta T, used for fan control 10: max delta T, used for fan control 11: specific heat capacity 12: setpoint heatload warning 13: setpoint Water Flow Loss Emergency Door Opening 14: setpoint High Temperature Emergency Door Opening 15: setpoint Condensation Pump Cycles (Warning) 16: setpoint Condensation Pump Running Time (Warning) 17: command for door opening, 0=lock door, 1=unlock door 18: KP parameter for PID controller 19: KI parameter for PID controller 20: KD parameter for PID controller 21: sampling time PID controller 22: number of installed fans 23: offset for cold water temperature 24: offset for hot water temperature 25: valve control mode 26: isolation valve inlet, manual control 27: isolation valve facility, manual control 28: isolation valve infrastructure, manual control 29: control valve facility, manual setting 30: control valve infrastructure, manual setting 31: fan control mode 32: fan 1, manual setting 33: fan 2, manual setting 34: fan 3, manual setting 35: fan 4: manual setting 36: setpoint for air difference pressure (fan control), this value is scaled with 1000 (e. g. 0.1 inch H2O are entered as 100) 37: KP parameter for Fan PID controller 38: KI parameter for Fan PID controller 39: KD parameter for Fan PID controller 40: sampling time Fan PID controller 41: dewpoint Offset for dewpoint average Value 42: max IT Air Temperature, Limit for dewpoint control 43: dewpoint control mode, 0 = off, 1 = On