Here the result of automatic load control can be read. All output were tested in pairs (0-1, 2-3, 4-5, 6-7, 8-9, 10-11). If an error occours at one output, both output of an pair will be switched of. For a properly function of the load control each output of a pair have to has a load. If there is no existing load, a pull down resistor can be used. Outputs with no load are automaticly detected and not part of the control function. The OCTETS are interpreted bit-by-bit, with each bit corresponding to an output. Bit 0 corresponds to the LSB. Octet 1: unused Octet 2: unused Octet 3: Bit 4-7: unused Bit 0-3: outputs 8-11 Octet 4: Bit 0-7: outputs 0-7.